13
SIT-TO-STAND TECHBENCH INSTALLATION MANUAL
Eaton.com/techbench
Sit-to-Stand Techbench
Installation Manual
G. Initialize the lift motor system
WARNING
UNPLUG BEFORE ENERGIZING OR OPERATING THE LIFT
SYSTEM
• MAKE SURE THAT THE PRECEDING ASSEMBLY STEPS
HAVE BEEN FOLLOWED AND ARE COMPLETED.
• VERIFY THE CORRECT POSITION OF ALL LIFT MOTOR
CONNECTORS. VERIFY THAT ALL LIFT MOTOR CABLES ARE
PROPERLY SEATED IN THEIR RECEPTACLES.
• MAKE SURE THAT THE VOLTAGE OF THE CONTROL BOX
IS CORRECT BEFORE THE SYSTEM IS CONNECTED TO THE
MAINS.
The To initialize the Lift motor system:
1� Temporarily plug the power cord into a nearby 120volt
AC outlet�
2� The Lift motor system is initialized by pressing and
holding the down button for a minimum of 20 seconds�
The motors will automatically lower to their bottom most
position, then run upwards approx� 3mm, and then down
again to their lowest position� Only release the button
when the movement has completed�
3� If the button is released before sequence is completed,
then the initialization is interrupted and the must be
started from the beginning�
4� It is sometimes necessary to press the down button
twice to start in initialization� This is because the system
can be in different modes when the initialization starts�
5� After initialization, press the up button to lift the work
surface (in this case the frame)�
WARNING
• IF THE CONTROL BOX MAKES UNUSUAL NOISE OR
ODORS, IMMEDIATELY UNPLUG THE UNIT FROM THE AC
RECEPTACLE.
•
INSPECT ALL CABLES TO ENSURE THAT THEY ARE NOT
DAMAGED, RECORD ALL ERROR CODES SHOWN ON
CONTROL PAD.
• DO NOT PLUG THE UNIT IN AGAIN. CONTACT TECHNICAL
ASSISTANCE FOR HELP USING CONTACT INFORMATION
IN SECTION 1 OF THE INSTALLATION MANUAL.
H. Final assembly
1� With 4mm Allen wrench (supplied), tighten all lift motor
screws (16X)�
2� The bench now can be up righted�
WARNING
USE CAUTION WHEN LIFTING WORK SURFACE. TWO PEOPLE
ARE REQUIRED TO AVOID INJURY.
SECTION III - Assembling the corner
and linear bench
