8
Sit-to-Stand Techbench
Installation Manual
SIT-TO-STAND TECHBENCH INSTALLATION MANUAL
Eaton.com/techbench
SECTION III - Assembling the corner
and linear bench
L x 1
H x 2
B. Wiring the bench - control pad
•
Route control pad wire in slot in work surface� Then out
thru bottom slot of work surface stiffener and to side
slot in the stiffener�
•
Plug RJ45 connector into lift motor controller�
•
Assemble control pad to work surface using #8 x ½" (2)�
•
Push wire clip hardware L over control pad wire in work
surface slot�
Hardware
required
Wire clip
retainer
Bottom slot in work
surface stiffener
Slot in work
surface stiffener
Front work
surface pull
slot
Control touch
pad
Lift motor
controller
receptacle
Control pad wire
#8 x
1
/
2
" flat
head hardware
H x 2
