4
Sit-to-Stand Techbench
Installation Manual
SIT-TO-STAND TECHBENCH INSTALLATION MANUAL
Eaton.com/techbench
Important safety instructions
DANGER Read all instructions before assembling and using this furnishing - Save these instructions
This bench has an electrically driven adjustable worksurface� In its
lowest position, the worksurface is very close to the support base
structure� The bench’s lift motors have sensors that will detect
an obstruction when moving downward� When an obstruction is
sensed, the worksurface will automatically begin to raise�
14� Installation and assembly must be performed by qualified
personnel�
15� Ensure that the floor is able to withstand the weight of the
bench when fully loaded�
16� Ensure the bench is plumb and level for proper operation�
Route all power cords and cabling as instructed, away from
any possible pinch points or moving parts�
17� To reduce risk of personal injury and product damage, always
ensure a sufficient amount of personnel are present when
unpacking, moving and assembling the bench system�
Failure to adhere to these warnings may result in serious
injury or property damage.
DANGER
Bench capacities
Dynamic load capacity of height adjustable lift motors:
1,000 lb�
Work surface capacity corner and linear:
900 lbs�
Below work surface shelf capacity:
Half shelf: 100 lbs�
Full shelf: 150 lbs�
Above work surface shelf capacity (Tech Organizer):
Linear shelf ea: 75 lbs� @ 24" max� height above work surface
Corner shelf: 100 lbs� @ 24" max� height above work surface
WARNING
Do not apply loads that exceed the capacity of the bench�
The applied load includes any items installed or placed onto the
bench worksurface or into the base cabinet compartments after
receipt of the bench from the carrier� Applied loads include (but
are not limited to) monitor poles, electronic equipment, power
distribution units, and cabling�
DANGER
DANGER
– To reduce the risk of electric shock: This bench
includes two power cords� Always fully unplug this bench from the
electrical outlets before cleaning, testing, repairing or moving the
bench�
WARNING
1� This bench is for commercial use only�
2� Unplug from outlet before putting on or taking off parts�
NOTE: This bench includes power cords�
3� Close supervision is necessary when this furnishing is used by,
or near children, invalids, or disabled persons�
4� Use this furnishing only for its intended use as described in
these instructions� Do not use attachments not recommended
by the manufacturer�
5� Never operate this furnishing if it has a damaged cord or plug,
if it is not working properly, if it has been dropped or damaged,
or has become wet� Return the furnishing to a service center
for examination and repair�
6� Keep the cord(s) away from heated surfaces�
7� Never operate the furnishing with the air openings blocked�
Keep the air openings free of lint, hair, and the like�
8� Never drop or insert any object into any opening�
9� Do not use outdoors�
10� To disconnect, turn all controls to the off position, then remove
plugs from outlets�
11� WARNING: Risk of Electric Shock – Connect this furnishing to
properly grounded outlets only� See grounding instructions�
12� To reduce risk of electrical shock, this furnishing has polarized
plugs (one blade wider than the other)� These plugs will fit into
polarized outlets only one way� If a plug does not fit fully into
the outlet, reverse the plug� If it still does not fit, contact a
qualified electrician to install the proper outlet� Do not change
the plug in any way�
13� DO NOT, UNDER ANY CIRCUMSTANCE,
PLACE A BODY PART IN THE PATH OF THE
WORKSURFACE WHILE IT IS BEING
LOWERED�
DO NOT PLACE ANY OBJECT ON TOP OF THE
BENCH’S SUPPORT BASE THAT COULD INTERFERE WITH THE
TRAVEL OF THE WORKSURFACE�
SECTION I
