Eaton IQ 250, Руководство пользователя и инструкция по установке

Страница: 95 / 142

Chapter 8:
IQ 250/260 Meter Programming the IQ 250/260
www.eaton.com
IB02601006E
8-31
Performing Additional Tasks with IQ 250/260 Configuration Software
The following sections contain instructions for other tasks you can perform with the IQ 250/260 Configuration
Software.
Using Connection Manager
Use Connection Manager to Add or Remove Connection
Locations and/or Devices at Locations.
1. Click
Connection>Connection Manager
or click on the
Connect Mgr
icon. You will see the screen, shown on the
right.
List of Locations :
On the left side of the Connection Manager screen is a List
of Locations . These are the locations of one or more meters
to which you can connect. You can Add a Location and/or a
Device ; Edit a Location and/or Device ; or Remove a
Location and/or Device .
• To Add a Location :
a. Click on the Add button. You will see the Connection
Manager Location Editor screen. On this screen,
you program the Communication settings for each
New Location .
b. Type a Name for the New Location .
c. Click Serial Port or Network .
d. Enter Communications Settings :
Com Port: COM 1 - 99
Baud Rate: 1200 - 115200
Flow Control: None or Hardware
Data Bits: 8 (or 7)
Parity: None (Even, Odd)
e.
To Add a Device
:
- Click
Add Serial
(to add a Serial Port Connected Device)
or
Add Net
(to add a Network Connected Device) in the
Devices at Location
box. You can add up to
255 Devices
(Serial Port and/or Network connected) at one
Location
.
NOTES
:
• All devices must have the same connection parameters:
Baud, Parity and Flow Control.
• Multiple Devices slow down polling.