![background image](http://html1.mh-extra.com/html/eaton/emr-3mp0/emr-3mp0_installation-operation-and-maintenance-manual_3982316056.webp)
1.7
PowerPort-E
PowerPort-E is a parameter setting and evaluation software. Please see the separate
manual
(MN026001EN)
.
• Menu-controlled parameter setting incl. validity checks
• Offline configuration of all relay types
• Reading and evaluating of statistical data and measuring values
• Setting into operation assistance
• Display of the device status
• Fault analysis via event- and fault and waveform recorder
For a complete EMR-3MP0 configuration it is recommended to use the PowerPort-E setting
and evaluation software, because it is too cumbersome to make a large amount of
settings using the panel of the device.
For PowerPort-E, a PC with Windows (7, 8.x or 10) operating system is required.
Moreover, a connecting cable is required for a direct connection of the EMR-3MP0 with the
PC. This cable requires an USB connector of type “Mini B” on the EMR-3MP0 end (see also
╚═▷ “Slot X120 - PC Interface”
Alternatively, it is possible to establish a connection via Ethernet (TCP/IP), if the network
permissions allow this and if the EMR-3MP0 has been ordered with an Ethernet interface
(
╚═▷ “Communication Protocol Codes”
╚═▷ “Catalog Codes for the EMR-3MP0”
necessary TCP/IP-settings (IP address, subnet mask, gateway) have already been made
via the panel.
56
www.eaton.com
EMR-3MP0
1 EMR‑3MP0 Motor Protection Relay
1.7 PowerPort-E