Dynisco UPR700, Инструкция по установке и эксплуатации

Страница: 8 / 72

8
Installation Category: II
2.3 D
ISPLAY
S
PECIFICATION
Display: LED technology, custom type.
Upper Digits: Red color, 5 numeric digits, 7 segments with decimal point 13.2 mm high.
Lower Digits: Green color, 5 alphanumeric digits (British flag), 14 segments with decimal points.
12.7 mm high.
Bar Graph: Red color, 35 segment with 3% resolution. Displays continuous bar graph to indicate the
measured variable of the primary input (0-100% full scale). Alarm set point values displayed. Last
segment blinks for pressure greater than full scale value.
Indicators:
9 red LED’s annunciator for:
A1
Lit when alarm 1 is in alarm state
A2 Lit when alarm 2 is in alarm state
A3 Lit when alarm 3 is in alarm state
REM Lit when device is controlled by serial link
0-25-50-75-100-% These six LEDs are always on to improve the bar-graph indication.
2 green LED’s annunciator for:
PEAK
Lit when lower display shows the peak value
TEMP Lit when lower display shows the temperature input value (only for TC and
RTD input)
2.4 P
RIMARY
I
NPUT
S
PECIFICATION
Primary Input: Selectable between strain gage and linear by jumper and configuration.
Strain Gage Input: 350 Ohm, 2-4 mV/V. Excitation 10 V
±
7%. 6 wire connection.
Input Signal: -25/125% of full scale (approximately -10 / 50 mV).
Shunt Calibration: With or without shunt resistor (value programmable from 40.0 to 100.0%).
Zero Balance:
±
25% of full scale (approximately
±
10 mV).
Linear Input: Selectable between 0-5VDC, 0-10 VDC. 0-20 mA, 4-20 mA.
Auxiliary Power supply: 24 VDC / 1.5W
±
2% power supply for two or four wire transmitter.