Ducati Monster 696 2009, Руководство пользователя

Страница: 280 / 696

A
B
C
D
E
F
G
H
L
M
N
P
section
H 6
32 Monster 696/696+ - M.Y. 2009 - edition 00
Frame
If the ring nuts (5) with the clearance adjusters (4) were removed, proceed as follows.
Grease the threads of the clerance adjuster (4) and the ring nuts (5) taking care not to get any grease on face (B) of the clearance
adjuster (4).
Screw the clearance adjusters (4) into the ring nuts (5) so that the sides with the pin wrench notches are flush with the ring nuts,
as shown in the figure.
Screw the clearance adjusters (4) with the ring nuts (5) into the frame so that they lie flush with internal surfaces of the frame
lugs (C).
Withdraw the pin (13) from the engine block to release the rear subframe.
Apply the recommended grease to the threads of the pin (13) and of the nut (3).
Locate the frame (1) on the motorcycle and insert the pin (13) from the right-hand side.
Counterhold the pin (13) and tighten the nut (3) to the specified torque (Sect. C 3, Frame torque settings).
Align the rear subframe and the frame (1), inserting the special screws (6) but without tightening at this stage.
Remove the special screws (6) and tighten the clearance adjusters (4) to the specified torque (Sect C 3, Frame tightening
torques).
Locate service tool no.
88713.3166 on the ring nut (5) and fit the torque wrench to the tool.
While holding the clearance adjusters (4) firm, tighten the ring nuts (5) to the specified torque (Sect. C 3, Frame torque settings).
Lubricate the threads and the heads of the special screws (6), fit them in the frame and tighten them to the specified torque
(Sect. C 3, Frame torque settings).
B
5
B
4
B
C
1
3
6