Ducati Monster 696 2009, Руководство пользователя

Страница: 190 / 696

A
B
C
D
E
F
G
H
L
M
N
P
section
G 1
6 Monster 696/696+ - M.Y. 2009 - edition 00
Wheels - Suspension - Brakes
Overhauling the front wheel
Overhauling the front wheel bearings
Before checking the dimensions, check the wear on wheel bearings. Check for wear by hand after cleaning and degreasing the
bearings in their seats. Turn the inner race. Check the amount of radial and axial play. Excessive play will cause vibration and make
the bike unstable; in this case the bearings must be renewed. To remove the bearings (5) from the wheel hub, proceed as follows.
Position a drift (A) against the inner race of the bearing (5).
Tap the drift with a hammer to drive out the bearing. Apply the drift at different points to keep the bearing square during removal.
Important
Once removed, bearings must not be refitted. Before fitting new bearings, check that the housing is clean and free from scoring
and damage.
Grease the bearing seat and then push the new bearing into its seat.
Warning
Avoid getting grease on the braking surface of the disc during these operations as this could impair braking efficiency. Using a
tubular drift (B) which only exerts pressure on the bearing outer ring, drive the bearing fully into its seat. Ensure that spacer (6)
is fitted between the two wheel bearings.
5
Endfloat
Radial play
5
A
C
B
6
5