Ducati Monster 696 2009, Руководство пользователя

Страница: 321 / 696

A
B
C
D
E
F
G
H
L
M
N
P
section
L 6
23 Monster 696/696+ - M.Y. 2009 - edition 00
Fuel/Exhaust System
Refitting the throttle body
If the hoses (4) and (16) were removed, reconnect them to the throttle body with the hose clamps (3), positioning the hoses and
clamps as shown in the figure.
Notes
The air temperature sensor (7) is installed on the intake hose of the vertical cylinder (16); to refit, refer to Sect. M 3, Air pressure
sensor.
Warning
The hose (16) which mounts the air temperature sensor (17) should be installed on the same side of the throttle body as the
position sensor (2).
Notes
The end of the hose with the smaller diameter is to be connected to the throttle body.
Push the hoses fully onto the throttle body, aligning the moulding lines (E) on the hoses with the moulding lines (F) on the throttle
body, as shown in the photo.
Tighten the hose clamps to the specified torque (Sect. C 3, Frame torque settings), orienting them as shown in the photo and
making sure that they are correctly positioned on the seatings (G) of the hoses.
7
16
6 ± 1 mm
E
16
2
G
17
F