Ducati Monster 696 2009, Руководство пользователя

Страница: 660 / 696

A
B
C
D
E
F
G
H
L
M
N
P
section
P 5
70 Monster 696/696+ - M.Y. 2009 - edition 00
Electrical system
Remove the electric terminal connected to the neutral switch. Switch on the ignition switch (ignition key to ON position)
and ensure that the light illuminates when the terminal is earthed. If the light switches on, the neutral light switch should
be changed. If the light stays off, switch off the ignition (ignition key set to OFF) to switch off the instrument panel and
check for electrical continuity between the neutral switch and engine ECU with a multimeter.
The neutral light on the instrument panel is permanently illuminated.
Switch on the ignition (ignition key set to ON) and remove the electrical terminal from the neutral switch. If the light switches off,
the neutral light switch should be changed. If the light stays off, switch off the ignition (ignition key set to OFF) and use a
multimeter to check whether the section of circuit between neutral switch and engine ECU is earthed.
Oil pressure sensor
To test the operation of the engine oil pressure sensor (4), proceed as follows.
Use the DDS tester to check that the oil pressure in the engine oil circuit complies with the specified values (Sect. D 5, Check
the engine oil pressure)
If the engine oil pressure value is outside the specified range, check the oil circuit components and service as necessary.
If engine oil pressure value is within the specified range and the oil pressure warning light on the instrument panel stays off,
switch on the instrument panel (ignition key set to ON) without starting the engine, and disconnect the electrical terminal from
the pressure sensor and connect it to earth. If the warning light now illuminates, this means the sensor is defective and must
be replaced. If the warning light does not illuminate, use a multimeter and check for electrical continuity in the section of the
circuit between sensor and warning light on the instrument panel (this check must be performed with the ignition key set to OFF,
i.e. with instrument panel off).
If the engine oil pressure complies with the stated values and the engine oil pressure warning light on the instrument panel
is continuously illuminated, switch on the instrument panel (ignition key set to ON) and start the engine, then disconnect the
electrical terminal normally inserted on the pressure sensor. If the warning light now switches off, this means the sensor is
defective. If the warning light does not switch off, use a multimeter to check that the section of the circuit between sensor and
warning light on the instrument panel is not connected to earth (this check must be performed with the ignition key set to OFF,
i.e. instrument panel off).
Clutch switch
For the clutch switch (5) proceed in the same manner as for the brake light switches (see beginning of this paragraph).
4
5