Ducati 996S 2001, Руководство пользователя

Страница: 110 / 273

44
E
Adjusting headstock angle (fig. 33.1)
Loosen the two screws (1) on the frame r.h. side to
adjust the headstock angle.
Fully unscrew the screw (2) and turn the headstock end
(3) by 180° with a pin wrench.
Make sure the eccentric hole is on the same axis of
the through hole on the headstock. An arrow showing
timing position is marked on the top of the eccentric.
Fully screw the screw (2). Grease the screw threadings
(1) with SHELL Retinax HDX2 and tighten to 22 Nm.
Note
While performing the above, the handlebars should
not be fully turned.
When finished, the steering damper must be
repositioned. Undo the screw (4, fig. 33.2). Move the
damper rod joint to the frame hole (5). Apply medium-
strength threadlocker and tighten the screw (4)
previously removed.
Important
The steering lock can be used only if the headstock
tube is positioned at 24°30’.
fig. 33.1
fig. 33.2
ProCarManuals.com