Dreizler marathon M 10001.1, Руководство пользователя

Страница: 173 / 184

Work sheet - Maintenance and firing systems
dreizler A 3001 E - 18.12.2015 | A 2045 - 1.13 | EN - 02.05.2013 173
2. Mountings array
2.1 Burner valve, measure opening/closing times, check
valves for leakage. x
2.2 Main valve as above, check solenoid valves for hum-
ming. x
2.3 Start-up load valves as above, check volume setting. x
2.4 Gas pressure governor, function check for governabil-
ity (readjust). x
2.5 Gas filter, clean mats (replace where required), oil fil-
ter x
2.6 On the operation with special gases check the flash-
back safety device (deflagration arrester) according to
the regulations of the manufacturer x
2.7 Manometer, check display. x
2.8 Ball tap, check for leakage x
2.9 Coat mountings array with foaming agent to check for
leakages. x
2.10 Function check of tightness control unit (safety
device), check for leakage.
x
Inspection and maintenance work Annu
ally Measured values, comments,

'Actioned' stamp
3. Measurements after maintenance
3.1 Gas flow rate/ oil flow rate x
3.2 O2 / CO2 measurements x
3.3 CO measurements x
3.4 Measure suction/pressure in combustion chamber,
soot measurement, nozzle pressure, supply pressure
for liquid gas x
3.5 Measurements of waste gas and air temperature. x
3.6 Determination of waste gas losses. x
3.7 Gas pressure up/downstream of the regulator/oil pres-
sure x
3.8 Status of operating hours counter and impulse counter
(ORBIC burner management system) x
3.9 Generate test report and entry into the maintenance
book. x
Inspection and maintenance work Ann
ually Measured values, comments,

'Actioned' stamp