Dräger Multi-PID 2, Руководство пользователя

Страница: 26 / 107

26
Using the Multi-PID 2
Battery Charging
Before beginning operation of the Multi-PID 2, the battery pack must
be charged.
You can also remove the battery pack and replace it with a fully char-
ged spare battery pack (Part No. 83 23 622 or 83 17 670).
Removing and Replacing the Battery Pack
To remove the battery pack:
1. If the Multi-PID 2 has been turned on, turn it off by pressing the
ON/OFF key for five seconds and then releasing it.
2. Locate the battery hatch on the back of the instrument.
See Figure 4.
3. Loosen the two Phillips screws in the top of the battery hatch.
4. The battery hatch can now be removed.
5. Lift the battery pack out of the case and carefully disconnect the
battery pack connector from the Multi-PID 2.
6. Attach the connector from the charged battery pack to the
Multi-PID 2.
7. Place the battery pack in the Multi-PID 2 case. Ensure the battery
wires are not pinched or strained.
8. Ensure the wrist strap ring is in proper position. This ring holds the
wrist strap in place.
9. Replace the battery hatch and then replace the two screws. Do not
overtighten the screws as you will damage the case.
NOTE:
You must use the 220 V battery charger (Part No. 83 17 661) in
order to comply with the requirements of the applicable Council
Directives.
WARNING:
Do not remove or recharge the battery pack in a
hazardous location. danger of an explosion!
NOTE:
If you do not turn the Multi-PID 2 off before removing the battery
pack, you will reset the instrument and you will lose all logged
data and setup parameters.
NOTE:
The connector is polarized. It will only fit one way. Do not force
the connection.