Donaldson Torit DCE 2000 Series, Инструкция по установке, эксплуатации и обслуживанию

Страница: 30 / 43

Installation, Operation and Maintenance Manual
DCE 2000 Series Dust Collectors
30
1 Lift fan assembly into position.
2 Loosely replace bolts to locate the fan motor pedestal to the fan support
channels.
3 Bolt the fan assembly to the fan division panel.
4 Ensure the fan assembly is correctly positioned, then tighten bolts.
5 Replace fan section front panel or, on collectors with secondary/absolute
filter, replace secondary/absolute filter element and close fan section door.
6 Connect electrical cable to motor.
7 Replace internal baffles.
8 Replace left-hand panel of the acoustic diffuser.
9 Feed motor cable through left-hand panel and reconnect electrical cables
to terminal box.
10 Replace top plate and outlet grille or back panel.
11 Replace lifting brackets.
12 Switch on electric power.
13 Ensure correct fan rotation (refer to fan rotation label located on rear panel
of fan section).
table 3 – torQue Values for bolts WItH Iso metrIC tHread
* For nuts and bolts to ISO 4017.
8 mm 1 mm 20.1 mm² 10.4 Nm 15.3 Nm 17.9 Nm
7 mm 1 mm 28.9 mm² 17.2 Nm 25 Nm 30 Nm
8 mm 1.25 mm 36.6 mm² 25 Nm 37 Nm 44 Nm
10 mm 1.5 mm 58 mm² 50 Nm 73 Nm 86 Nm
12 mm 1.75 mm 84.3 mm² 86 Nm 127 Nm 148 Nm
14 mm 2 mm 115 mm² 137 Nm 201 Nm 235 Nm
16 mm 2 mm 157 mm² 214 Nm 314 Nm 368 Nm
18 mm 2.5 mm 192 mm² 306 Nm 435 Nm 509 Nm
20 mm 2.5 mm 245 mm² 432 Nm 615 Nm 719 Nm
22 mm 2.5 mm 303 mm² 592 Nm 843 Nm 987 Nm
24 mm 3 mm 353 mm² 744 Nm 1060 Nm 1240 Nm
27 mm 3 mm 459 mm² 1100 Nm 1570 Nm 1840 Nm
30 mm 3.5 mm 561 mm² 1500 Nm 2130 Nm 2500 Nm
nominal
diameter
torque value*
grade 8.8
thread
pitch
stress
area
grade 10.9 grade 12.9
maIntenanCe