Dodge 2004 Neon SRT4, Руководство по диагностике

Страница: 511 / 922

TEST ACTION APPLICABILITY
3 NOTE: A thorough visual inspection of the Evap system hoses, tubes, and
connections may save time in your diagnosis. Look for any physical damage
or signs of wetness at connections. The strong smell of fuel vapors may aid
diagnosis also.
Use the Miller Tool #8404 Evaporative Emissions Leak Detector (EELD).
Connect the SMOKE supply tip (black hose) to the service port, (if equipped) or
install the #8404-ADP service adapter in the NVLD filter line..
Set the smoke/air control switch to SMOKE.
Block the vent hose of the EVAP Canister.
NOTE: The flow meter indicator ball will not move at this point.
Press the remote smoke/air start button.
NOTE: Ensure that smoke has filled the EVAP system by continuing to press
the remote smoke/air start button, remove the vehicle fuel cap, and wait for
the smoke to exit. Once smoke is indicated reinstall the fuel cap.
NOTE: For optimal performance, introduce smoke into the system for an
additional 60 seconds; continue introducing smoke at 15 second intervals,
as necessary.
While still holding the remote smoke/air start button, use the white light (#8404-
CLL) to follow the EVAP system path, and look for the source of the leak indicated by
exiting smoke.
If a leak is concealed from view (i.e., top of fuel tank), release the remote smoke/air
start button, and use the ultraviolet (UV) black light #8404-UVL and the yellow
goggles 8404-20 to look for residual traces of dye that are left behind by the smoke.
The exiting smoke deposits a residual fluid that is either bright green or bright
yellow in color when viewed with a UV light.
NOTE: Carefully inspect the vent side of the EVAP Canister. Due to the
filtering system in the canister the smoke or dye may or may not be visual.
Introducing smoke into the filtered side of the canister may assist in
locating the leak.
Was a leak found? All
Yes
→
Repair or replace the leaking component as necessary.
Perform POWERTRAIN VERIFICATION TEST VER - 5 - NGC.
No
→
Go To 4
4 WARNING: WHEN THE ENGINE IS OPERATING, DO NOT STAND IN A
DIRECT LINE WITH THE FAN. DO NOT PUT YOUR HANDS NEAR THE
PULLEYS, BELTS OR FAN. DO NOT WEAR LOOSE CLOTHING.
Review the DRBIII
t
Freeze Frame information. If possible, try to duplicate the
conditions under which the DTC was set.
Refer to any Technical Service Bulletins (TSB) that may apply.
NOTE: A loose gas cap could have caused this DTC to set. Make sure gas cap
is tight and in good condition. Ensure the gas cap meets OEM specifications.
Perform a visual and physical inspection of the entire Evaporative Emission system.
Check for the following conditions:
- Holes or cracks
- Loose seal points
- Evidence of damaged components
- Incorrect routing of hoses and tubes
- Fuel Cap gasket seal
Were any of the above conditions found?
All
Yes
→
Repair as necessary.
Perform POWERTRAIN VERIFICATION TEST VER - 5 - NGC.
No
→
Test Complete.
175
DRIVEABILITY - NGC
P0456-EVAP SYSTEM SMALL LEAK —
Continued