Docomo Style P-06A, Инструкция по эксплуатации

Страница: 97 / 565

95
S
o
un
d/
Sc
re
en
/L
ig
ht
Se
tt
in
gs
The confirmation tone sounds twice when charging starts/ends.
1 m
Settings Other settings Battery Charge sound
ON or OFF
When a call is likely to be disconnected midway due to bad radio wave
conditions, an alarm sounds to inform you right before disconnection.
1 m
Settings Talk Quality alarm Select an alarm.
No tone . . . . . Does not sound.
High tone . . . High alarm sounds.
Low tone . . . . Low alarm sounds.
<Charge Sound>
Setting Charging-start/end Tones
Information
p You cannot change the volume for charge sound.
p
The charging confirmation tone does not sound when a display other than the
Stand-by display is shown or during Manner Mode or Public Mode (Drive Mode).
+ m - 7 - 5
<Quality Alarm>
Sounding Alarm when a Line is Likely to
be Disconnected
Information
p
You might be disconnected without hearing an alarm if radio wave conditions
deteriorate suddenly.
p
An alarm for “Quality alarm” sounds only from the earpiece during a videophone call.
You can set the duration of the ring tone which sounds for incoming
i-mode mail, SMS messages, Chat mail and Messages R/F.
1
m
Settings Sound Mail/Msg. ring time
Select a type of mail or message ON or OFF
Enter a ring time (seconds).
p
Enter in two digits from “01” through “30”.
You can set where you make the ring tone and alarm sound from for
when you connect an earphone/microphone (option).
1
m
Settings Sound Headset usage setting
Headset and speaker or Headset only
+ m - 6 - 8
<Mail/Message Ring Time>
Setting Ring Time for Mail and Messages R/F
+ m - 5 - 1
<Headset Usage Setting>
Sounding Ring Tone from Earphone Only
Information
p Even when you set “Headset only”, the ring tone sounds from both the earphone and
speaker about 20 seconds after ringing starts. However, the tone does not sound from
the speaker but sounds from the earphone only even after 20 seconds have elapsed if
the tone sounds for the operations other than incoming calls, incoming mail, and
alarm notification.
p Even when you set “Headset only”, the tone sounds from the speaker when you do
not connect any earphone/microphone or when you start shooting still or moving
images.