Docomo Style P-06A, Инструкция по эксплуатации

Страница: 45 / 565

43
Before Using the Handset
When the FOMA phone is turned on, an estimate of the battery level is
indicated by the icon.
・
Almost full. . . . . . . . . . . . . . . . . . .
・
Getting low . . . . . . . . . . . . . . . . . .
・
Almost empty . . . . . . . . . . . . . . . .
p Charge the battery when it is almost empty.
You can check an estimate of the battery level by the display and sound.
1 m
Settings Other settings Battery Battery level
p
The pictograph disappears in about three seconds.
The display on the right appears and the low battery alarm
sounds for about 10 seconds. To stop this alarm, press any
key other than
<
and
>
. About one minute later, the FOMA
phone will be turned off.
p During a call, a beeping tone from the earpiece notifies you of
the low battery. About 20 seconds later your call will be cut
and then one minute later the FOMA phone will be turned off.
<Battery Level>
Checking Battery Level
Check by Display and Tone
Almost full Getting low Almost empty
※
Almost empty.
Charge the battery.
Three beeps Two beeps One beep
When the battery is running out
Recharge Battery
display
1
Press and hold
h
for at least one
second.
After the Wake-up display (see page 99) is displayed, the
Stand-by display appears.
p If you have stored many Phonebook entries or mail
messages, it may take a while for the display to appear.
p
If Set Time is set, the current date and time are shown.
p When “ ” is displayed, the FOMA phone is out of the
service area or in the place where the radio waves do
not reach. Move to a location where “
” disappears.
p
If “Starting system Wait a minute” is displayed when
you turn on the power, wait for a while and then
proceed.
Enter the four- to eight-digit Terminal Security Code after turning on the power. When
you enter the correct Terminal Security Code, the Stand-by display appears. If you enter
the incorrect Terminal Security Code five times in succession, the power turns off.
(However, you can turn on the power again.)
Enter the four- to eight-digit PIN1 code after you turn on the power. When you enter the
correct PIN1 code, the Stand-by display appears. See page 116 for PIN1 code.
Enter the four- to eight-digit PIN2 code after you turn on the power. When you enter the
correct PIN2 code, the Stand-by display appears. If you press
r
or
h
without
entering the correct PIN2 code, “Auto reset setting” is set to “OFF” and the Stand-by
display appears. See page 116 for PIN2 code.
<Power ON/OFF>
Turning Power On/Off
Turn Power On
Stand-by display
When your UIM is replaced (except during Omakase Lock)
When “PIN1 code entry set” of “UIM setting” is set to “ON”
When “Auto reset setting” of “Notice call cost” is set to “ON”
(except during Omakase Lock)