Docomo FOMA D702iF, Руководства

Страница: 81 / 451

79
Mak
ing/
Recei
vi
ng
Vi
deoph
one Cal
ls
2
t
3
Talk with the other party
4
Press
f
when you finish the call
･
You can also end the call by closing FOMA terminal. To keep the call connected when you close FOMA
terminal, change the setting in Close Setting.
INFORMATION
●
You can also make a videophone call by performing in order of Steps 2, Step 1. A videophone call will be made
automatically about 5 seconds after you press
t
and enter the phone number.
●
You can make videophone calls by attaching Chaku-moji.
☛
P53
●
You can make videophone calls by setting conditions.
☛
P55
●
When
Speakerphone
is set to
ON
in Videophone Settings and Silent Mode is active, if you make a videophone call, a
confirmation screen appears asking whether to switch to the speakerphone call. Select Yes or No .
●
If a videophone call is not connected, one of the following messages appears on the screen and then the standby
display returns. Note that the displayed message may not reflect the status of the other party’s terminal correctly,
depending on the type of the terminal or the network service used by the other party.
*1 The message may also appear when the other party is in packet communication, depending on his/her terminal.
*2 As of August 2006, the message may also appear when the other party has activated Voice Mail Service.
Message Description
Check number, then redial . You dialed the phone number not used.
Busy. The other party is busy.*
1
Out of service area/power off . The other party is outside the service area or the other party’s terminal is turned off.
Set Caller ID to ON. This message appears in case of connecting without notifying the caller ID (when
accessing to V-Live or visualnet).
Redial using voice call . This message appears when the other party has activated Call Forwarding Service
with the forwarding destination set to a terminal incompatible with videophone.* 2
Busy with packet transmission . The other party is in packet communication.
Connection failed. Set Caller ID Notification to Notify and dial again.
･
The message may appear in cases other than the above.
Your image is displayed while being connected.
･
If the other party is busy, you will hear a busy signal. The message,
Busy
. or
Connection failed
. appears on the screen. Press
f
to end the call and call
again later. You can call back quickly by using Redial.
･
Pressing
t
while being connected sends the substitute image set in Image
Setting. When the substitute image is set to Chara-den, Chara-den may not be
displayed. If this happens, the default image for the substitute image setting is
sent to the other party.
☛
P89
･
Charging begins when
Connected to videophone
. appears.
The other party’s voice comes out of the speaker (Speakerphone function).
･
To put the call on hold:
o
･
To turn on/off the speakerphone function:
a
or
n
･
Depending on the other party’s settings, the substitute image may be
displayed.
･
To disable turning on the speakerphone function automatically, change the
setting in Videophone Settings.
Makin
g
videoph
one calls
Next