DL JCPT-HD/DC Series, Руководство по обучению, Страница: 44 / 119

培训手册
Training Manual
操作
Operation
JCPT-HD/DC
www.cndingli.com
4-8
6
三个灯同时闪烁五次
The 3 LED is flashing five
times at the same time
输出电流过大。充电器内部故障，退回返修。
Output current is too large. Internal failure of charger,
return to factory for repairing.
7
三个灯同时闪烁六次
The 3 LED is flashing six
times at the same time
电池电压过高，检查并确保连接正确的输出电池电压。
Battery voltage is too high, check and assure that the
correct output battery voltage is connected.
8
三个灯同时闪烁七次
The 3 LED is flashing
seven times at the same
time
电池电压过低，检查并确保连接正确的输出电池电压。
Battery voltage is too low, check and assure that the
correct output battery voltage is connected.
1.5
安全臂的使用（
How To Use The Safety Arm
）
1)
升起平台到距离地面约
2.5m
高度。（
Raise the platform approximately 2.5 m from the
ground.
）
2)
提起安全臂，移动安全臂到剪叉轴套中间，向上旋转至垂直状态。（
Lift the safety arm, move
it to the center of the scissor arm and rotate up to a vertical position.
）
3)
降低平台高度，直到安全臂与轴套管完全接触。降下平台时，要远离移动部位。（
Lower the
platform until the safety arm rests securely on the link. Keep clear of the safety arm when
lowering the platform.
）
注意：使用安全臂支撑时平台上不得有载荷。（
Don’t engage the safety arm unless unload
the platform.
）

JCPT0807HD/DC ~JCPT1212HD/DC
、
JCPT0807GDC
有一个安全臂，检修时必须将其撑起，否则会造成严重事故，甚至人员的伤亡。（
The safety
arm has to be engaged when scissor inspection, or cause to hurt or death
.
）