DL JCPT-HD/DC Series, Руководство по обучению, Страница: 43 / 119

培训手册
Training Manual
操作
Operation
JCPT-HD/DC
www.cndingli.com
4-7

充电器故障排除；新款（
The charger fault trouble shooting
；
New version
）
序号
No.
故障现象
Fault Description
解决方案
Solution
1
LED
灯都不亮
No LED is working
检查输入电压，如果正常更换充电器。
Check the input voltage,if good, the charger should to be
replaced.
2
三个灯同时闪烁一次
The 3 LED is flashing one
time at the same time
输出没接电池或接反，短路，坏节。
1)
检查电池组是否连接正确。
2)
检查充电器是否连接正确。
3)
检查电池组中的单个电池是否损坏。
The battery is not connected or the battery voltage is too
low.
1) Check battery connection is correct.
2) Check charger connection is correct.
3) Check each battery is good.
3
三个灯同时闪烁两次
The 3 LED is flashing two
times at the same time
市电不正常（电压）。
1)
检查
AC
电源线是否连接在充电器和
AC
插座之间。
2)
确保
AC
插头紧插在
AC
插座上无松动。
4
三个灯同时闪烁三次
The 3 LED is flashing
three times at the same
time
充电器高温保护。
1)
充电器内部或环境温度过高，充电器将关闭并进入高温
保护模式。请把充电器放在通风良好的环境工作。
2)
断开充电器，等
15-20
分钟后再重新连接充电。
Charger high temperature protection.
1) Charger shuts down and enters protection mode due
to charger/environmental temperature is too high.
Please place the charger in a well-ventilated
environment.
2) Disconnect the charger and wait for 15-20 mins before
reconnection for charging.
5
三个灯同时闪烁四次
The 3 LED is flashing four
times at the same time
电池高温保护。
1)
当电池温度超过
50
度时，充电器限制充电电流甚至停
止充电以防电池过热。
2)
断开充电器，等
15-20
分钟后再重新连接充电。
Battery high temperature protection.
1) Charger will reduce current even stop charging when
the battery temperature exceeds 50
℃
.
2) Disconnect the charger and wait for 15-20 mins before
reconnection for charging.