Dish Network Dish 322, Руководство пользователя

Страница: 24 / 128

Chapter 2
Page 20
Receiver Description and Installation
5. Turn on the nearby TV.
6. Tune the TV to channel 3.
7. You should see the
Point Dish
screen.
8. If you do not see the correct screen, tune the TV to channel 4.
Note
: If you want to change the channel that the
CH 3-4 OUT
connection
provides to your TV, see Changing the TV1 and TV2 Output Channels
on page 26.
9. If you want a reminder of which TV channel (3 or 4) to tune for
watching satellite programming, place one of the channel stickers
(3 or 4) near or on your TV.
RCA and S-Video Connections (TV1)
1. Connect one of the following video cables:
• RCA
video cable (yellow) from the receiver TV1 outputs to the
nearby TV’s
RCA
video input.
•
S-V
IDEO
cable from the receiver TV1 outputs to the nearby TV’s
S-
V
IDEO
input.
2. Connect the
RCA
audio cables (red and white) from the receiver TV1
outputs to the nearby TV’s audio inputs. If the TV has only one input for
this type of audio, connect it to the right (R) phono (RCA) audio output
on the receiver.
3. Make sure your nearby TV is on and set to receive TV from the correct
audio and video inputs. Refer to the instructions that came with your TV.
4. Plug in the power cord for the receiver.
5. Turn on the receiver with the front panel power button and make sure the
green TV1 indicator is lit.
6. You should see the
Point Dish
screen.
Confirm Remote Control 1 Operation
After the nearby TV has been connected to a TV1 output using one of the
methods above, do the following to confirm that the IR Remote Control 1
controls the receiver:
1. Make sure that fresh batteries are installed properly in the IR Remote
Control 1.
2. Press the SAT button to put the IR Remote Control 1 in SAT mode to
control the satellite receiver.
3. Use the Remote Control 1 arrow keys to move around the
Point Dish
screen. If you are able to move around in the
Point Dish
screen, you
confirmed that Remote Control 1 is controlling the receiver.
Tip: The channel
stickers are located
inside the front
cover of this guide.
Tip: Remote
Control 1 is used to
control TV1 menus
on the nearby TV.
Remote Control 2
is used to control
TV2 menus on the
remote TV(s).