Dish Network Dish 322, Руководство пользователя

Страница: 90 / 128

Chapter 3
Page 86
Using the System
Telephone Connection Test
This test checks that the receiver telephone connection is correct. Select the
Connection
option to begin the test. The receiver displays a message asking
you to wait until the test is done.
• If the telephone connection is correct, the receiver displays a
Phone
Connection OK
message.
• If the receiver highlights the
Done
option, select the
Dial Out
option so
the receiver can make a toll-free call to the Customer Service Center.
The receiver displays a message asking you to wait until the call is done.
When the call is done, select the
Done
option to exit the test menu.
• If the telephone line is not connected properly, the receiver displays a
failure message. In this case, check the telephone connection and then
repeat the test.
Note
: If you have the receiver connected to a DSL (Digital Subscriber
Line) phone line, it may cause this test to fail. If so, you will need to
install a DSL filter between the receiver and the phone jack on the wall.
You should be able to get a DSL filter from your DSL provider or your
local electronic parts store.
System Updates
Your receiver includes a feature that allows you to set the time in
which your receiver downloads
Program Guide
information. When the
Updates
feature is enabled, the receiver will shut off every day at the same
time receive a software update. The default time for this feature is 3:00 a.m.
1. Press the
MENU button.
2. Select
System Setup
.
3. Select
Installation
.
4. Select
Updates
.
5. Highlight the
Activation
field.