Dish Network Dish 322, Руководство пользователя

Страница: 28 / 128

Chapter 2
Page 24
Receiver Description and Installation
19. You may need to change the cable connection on the splitter that sends
the TV signal throughout your house. Move the cable coming from the
receiver
CH 21-69 O
UT
from the output of the splitter to the input of the
splitter using the instructions below.
The following figure shows an example of what your splitter may look
like. Your splitter may look different. The places where the splitter
indicates
O
UT
refers to all TVs connected to your cable system. The
places where the splitter indicates
I
N
refers to where the signal is fed into
the splitter.
20. Find where the TV signal is distributed throughout your house. It should
be near where the cable TV service enters the house.
21. Disconnect the cable TV service cable or antenna cable from the splitter
input, if necessary. Make sure the disconnected cable is capped or
otherwise protected from the weather.
22. Disconnect the cable coming from the receiver
CH 21–69 O
UT
port from
the splitter. If you do not know which cable this is, go to the next step.
Otherwise, go to step 24.
23. If you have multiple TVs on the cable system, do the following to
determine which cable on the splitter is coming from the receiver:
•
If you have at least some picture on your TV(s), turn on all remote
TVs connected to the cable system. Disconnect and reconnect each
cable one by one, observing what happens to the TV(s). When all
remote TVs lose the signal, you have disconnected the receiver’s
cable. If only some or one TV loses the signal, then you have
disconnected a cable from the TV(s).
• If the above step does not work, disconnect one of the output cables
and connect to the splitter input. If you do not see a picture, connect
the cable back to its output. Repeat this step on every connection
until you get a picture on the remote TV(s).
24. Reconnect the receiver’s cable to the input of the splitter.
25. Make sure you have a good picture on your remote TV(s).
26. To remind you which TV channel your satellite programming is on,
write the channel number you wrote in step 8 on a blank channel sticker
and place it on or near your remote TV(s).
1 Input, 4 Output (4-Way) Splitter
Tip: The channel
stickers are
located inside the
front cover of this
guide.