Digital Equipment PRIORIS MTE, Руководство по техническому обслуживанию

Страница: 51 / 73

Digital PRIORIS MTE Server Troubleshooting
MCS Logistics Engineering - Nijmegen 51
P
R
I
O
R
I
S
M
T
E
Beep Codes for Nonfatal Errors
The table below lists the beep codes when it encounters a nonfatal error. This table lists nonfatal errors that do
not lock up the computer. Fatal errors that lock up the computer are listed in a separate table.
Beep Code Error Message
3-3-4
Screen memory failure
3-4-1
Screen initialization failure
3-4-2 Screen retrace failure
Server Troubleshooting
Problem Possible Cause Action
No response
when the
computer is
turned on Main logic board failure. Replace Main logic board.
Power is on, but
there is no
screen display
Brightness and contrast controls
are not correctly set.
Monitor cable is incorrectly
installed Adjust the brightness and contrast controls.
Check all monitor connections.
Computer does
not boot from
an IDE hard
disk drive
Operating system software is not
installed on the IDE hard disk
drive.
IDE hard disk drive is not
correctly formatted or the
requested partition does not exist.
There is no software on the
requested partition.
IDE hard disk drive jumpers
incorrectly set.
IDE drive type incorrect.
IDE main logic board jumper
incorrectly set.
Loose cables.
Install the appropriate operating system.
Format the IDE hard disk drive or correctly partition
the IDE hard disk drive using the supplied operating
system software.
Install software on the requested partition.
Refer to the supplied IDE hard disk drive kit
installation instructions.
Run the SCU to identify the correct drive type. See
drive type label on drive or consult drive
documentation.
Set the jumper for IDE operation; refer to the SCU.
Secure all cable connections.