Digital Equipment EK-SFXXS-SG-003, Руководство по обслуживанию

Страница: 131 / 224

SF7x Storage Enclosure FRU Replacement 6–23
Example 6–5 (Continued) PARAMS Dialog Restoring Disk ISE
Parameters
NOTE: BEFORE RESPONDING TO THE FOLLOWING QUESTION, SET THE MSCP SWITCH
TO THE OFF OR DOWN POSITION.
Changes require controller initialization, ok? [Y/(N)] Y
Initializing...
NOTE: It takes approximately 1 minute before the following message prints.
%HSCPAD-S-REMPGMEND, Remote program terminated - message number 3.
%HSCPAD-S-END, Control returned to node CLOUDF
$
7. If you did not put the MSCP switch in the enable or down position
before allowing the controller to initialize, you must do so now.
WARNING
Failure to put the MSCP switch in the enable or down position
will result in the loss of VMS communication with this disk
ISE at the next power-up.
6.1.3.4 Testing the Disk ISE
Once the disk ISE parameters are set, test the disk ISE by using the local
program DRVTST. DRVTST is accessed in the same way as PARAMS,
using the SET HOST/DUP command. In this case, instead of specifying
PARAMS, you specify DRVTST:
$ SET HOST/DUP/SERVER=MSCP$DUP/TASK=DRVTST nodename
CAUTION
• If you have changed only a drive module in a disk ISE, answer
the questions to force a read-only test. Do not run the write
/read test as it will destroy the customer data on the HDA.
• If you have replaced an HDA, or an entire disk ISE, allow this
test to perform write/read testing by responding accordingly
to the questions. The write/read test will destroy the customer
data on the HDA.