Virtual Private Networks (VPN)
OpenVPN
IX10 User Guide
317
4. Set the mode used by the OpenVPN server:
(config vpn openvpn server
name
)> device_type
value
(config vpn openvpn server
name
)>
where
value
is one of:
n
TUN (OpenVPN managed)
—Also known as routing mode. Each OpenVPN client is
assigned a different IP subnet from the OpenVPN server and other OpenVPN clients.
OpenVPN clients use Network Address Translation (NAT) to route traffic from devices
connected on its LAN interfaces to the OpenVPN server.
n
TAP - OpenVPN managed
—Also know as bridging mode. A more advanced
implementation of OpenVPN. The IX10 device creates an OpenVPN interface and uses
standard interface configuration (for example, a standard DHCP server configuration).
n
TAP - Device only
—An alternate form of OpenVPN bridging mode, in which the device,
rather than OpenVPN, controls the interface configuration. If this method is is, the
OpenVPN server must be included as a device in either an interface or a bridge.
See
for information about OpenVPN modes. The default is
tun
.
5. If
tap
or
tun
are set for
device_type
:
a. Set the IP address and subnet mask of the OpenVPN server.
(config vpn openvpn server
name
)> address
ip_address/netmask
(config vpn openvpn server
name
)>
b. Set the firewall zone for the OpenVPN server. For TUN device types, this should be set to
internal
to treat clients as LAN devices.
(config vpn openvpn server
name
)> zone
value
(config vpn openvpn server
name
)>
To view a list of available zones:
(config vpn openvpn server
name
)> firewall zone ?
Zone: The zone for the local TUN interface. To treat clients as LAN
devices this would usually be
set to internal.
Format:
any
dynamic_routes
edge
external
internal
ipsec
loopback
setup
Current value:
(config vpn openvpn server
name
)>
Содержание IX10
