Virtual Private Networks (VPN)
OpenVPN
IX10 User Guide
316
l
any
: No limit to IPv6 addresses that can access the service-type.
d. Click
again to list additional IP addresses or networks.
n
To limit access to hosts connected through a specified interface on the IX10 device:
a. Click
Interfaces
.
b. For
Add Interface
, click
.
c. For
Interface
, select the appropriate interface from the dropdown.
d. Click
again to allow access through additional interfaces.
n
To limit access based on firewall zones:
a. Click
Zones
.
b. For
Add Zone
, click
.
c. For
Zone
, select the appropriate firewall zone from the dropdown.
See
for information about firewall zones.
d. Click
again to allow access through additional firewall zones.
11. (Optional) Click to expand
Advanced Options
to manually set additional OpenVPN
parameters.
a. Click
Enable
to enable the use of additional OpenVPN parameters.
b. Click
Override
if the additional OpenVPN parameters should override default options.
c. For
OpenVPN parameters
, type the additional OpenVPN parameters.
12. Click
Apply
to save the configuration and apply the change.
Command line
1. Select the device in Remote Manager and click
Actions
>
Open Console
, or log into the IX10
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an
Access selection
menu
. Type
admin
to access the Admin CLI.
2. At the command line, type
config
to enter configuration mode:
> config
(config)>
3. At the config prompt, type:
(config)> add vpn openvpn server
name
(config vpn openvpn server
name
)>
where
name
is the name of the OpenVPN server.
The OpenVPN server is enabled by default. To disable the server, type:
(config vpn openvpn server
name
)> enable false
(config vpn openvpn server
name
)>
Содержание IX10
