Dieci Agri Farmer, Руководство по эксплуатации

Страница: 99 / 272

C/25
- ATTENTION
:
- Read the SAFETY REGULATIONS (contained in this manual) carefully for the safety of all personnel and your vehicle.
(fig.34/C)
0
1
2
E
IGNITION SWITCH
(fig.34/C)
The ignition switch, with the key, allows you to:
- Switch on the instruments.
- Switch on the diesel engine.
- Release the parking brake automatically with the diesel
engine in motion (fig.34/C Pos.”1”).
- Automatically engage the parking brake with the diesel
engine off (fig.34/C Pos.”0”).
Conditions for start-up
Start-up can only occur if:
- The operator is correctly seated in the driver’s seat.
- The gear selector is in the “N”, or neutral, position.
Switching on instruments
Turn the key to position “1” (fig.374C) to power the electrical/
electronic instruments.
When the dashboard is switched on, a check will be carried
out on the instruments with all the indicator lights switched on
and emission of an acoustic signal.
These will remain on until the engine is switched on:
- Battery indicator light
- Engine oil pressure indicator light
Other indicator lights may remain lit depending on the
functions activated.
When the engine is running, the indicator lights signalling
faults/malfunctions should go off and only those referring to
active functions should remain switched on. If this is not the
case, consult the “maintenance” chapter of this manual and
contact a diEci service centre.
Start-up
- Turn the key to position “1” (fig.34/C) to power the instruments.
- Turn the key to position “2” (fig.34/C) and keep it there
for a few seconds in order to start-up.
- Once the engine has been started, release the key.
In the engine does not start within 5 seconds, try again at
regular 15 second intervals to avoid overloading the starter.
During the first few minutes of use, keep transfer and load
lifting speed low in order to heat up the engine and hydraulic
oil. Operate at low RPMs (max 1500), avoiding sharp ma-
noeuvres and accelerations until the temperature has risen.
- attEntion
Bring the engine to a high number of RPMs before high
temperature and pressure can cause any serious damage to
the engine or the hydraulic system.
- attEntion
With the motor started, the automatic parking brake disen-
gages. Before starting up the vehicle, always verify that the
parking brake has been manually engaged using its switch.
To release the parking brake when the engine is stopped,
refer to the paragraph, “towing the vehicle”.
- attEntion -
If the engine cannot be started, check that an emer-
gency button has not been pressed (fig.34/C Pos.”E”). If
pressed, contact the Safety Manager to make sure there is
no maintenance in progress, malfunctioning of the vehicle or
dangerous situations.
If the engine does not start , consult the “maintenance”
chapter of this manual and contact a diEci service centre.