Dieci Agri Farmer, Руководство по эксплуатации

Страница: 38 / 272

B/18
Mod. Agri Farmer
Safety Regulations
ELECTROMAGNETIC INTERFERENCE
- If supplementary equipment is installed by the client, the
user must verify if the installation causes any type of in-
terference with vehicle’s instruments.
If this is the case, the user must eliminate this interference.
It is important to pay careful attention to mobile attachments
such as radio communications (telephones) which must be
installed by specialised technicians and used with externally
mounted antennas.
In general, all additional electrical equipment installed must
comply with EMC Directive EC/2004/108 and must carry the
"CE" marking.
VIBRATIONS
Take into consideration the following precautions to reduce
the operator’s exposure to vibrations:
- Always use equipment that is appropriate for the type of
work being performed.
- The driver's seat must be properly adjusted.. In-
spect and, if necessary, repair seat suspensions and
adjustment mechanisms.
- Make sure that the vehicle is kept in good condition, follow
vehicle maintenance schedule as described in this manual.
- Steer, accelerate, brake, change gears, move attach-
ments slowly.
- While driving, adjust vehicle speed to minimise the vibra-
tion level. Reduce speed to prevent risk of jolting. Transport
the vehicle if the distance between work sites is significant.
- Keep the work site in good condition, remove rocks and
obstacles, fill-in depressions or holes, etc.
- To avoid back problems, use the vehicle only if in good
health conditions. The operator should take periodic
breaks to reduce the amount of time spent seated in
the same position. Never jump down from the cab or the
vehicle. Avoid repeatedly handling and lifting loads.
1) Vibration values on the seat
Vibration emission value measured at = 1,8 m/s
2
Uncertainty factor K = 0,5 m/s
2
Values determined in compliance with standard EN 13059
Agri Farmer
2) Vibration values on the steering wheel
Vibration emission value measured at = 4,5 m/s
2
Uncertainty factor K = 2,2 m/s
2
Values determined in compliance with standard EN 13059