Dieci Agri Farmer, Руководство по эксплуатации

Страница: 197 / 272

D/33
- ATTENTION
:
- Read the SAFETY REGULATIONS (contained in this manual) carefully for the safety of all personnel and your vehicle.
AIR CONDITIONING (OpTIONAl)
Cleaning the system
- attEntion -
IT IS MANDATORy TO uSE ThE I.p.D. to carry out the
maintenance/control operations.
1. Park the vehicle on a level and compact surface.
2. Switch off the engine and remove the ignition key, hang up
a sign in the cab that reads “maintenance work under way”.
3. Disconnect the battery by acting on the “battery isolator
switch” see page D/14.
4. Wait for the engine to cool.
5. Remove the protective guard (fig.69/D Pos”1”).
6. Clean the condenser (fig.70/D Pos”1”), directing the
compressed air, at a maximum pressure of 7 bar, throu-
gh the radiant mass, from the side opposite the normal
air flow. Jets of air must be directed perpendicularly to
the surface of the radiator.
7. Be careful not to damage radiator flaps.
8. After cleaning, replace the condenser.
For the safety specifications, refer to chapter “B”, “Car -
rying out maintenance in safety” paragraph page b/16.
- attEntion
Should the conditioning system not work properly, immedia-
tely inspect the condenser.
Check the gas load every year via the corresponding val-
ves (fig.71/D Pos”2”).
- attEntion
Replace the radiator filter (fig.70/D Pos”2”) every 2 years .
Its breakage could cause serious damage to the conditio-
ning system and cause the introduction of particles into the
air that are harmful to the operator’s health.
Turn on the air
conditioning for two minutes every 15 days, even during the
winter. In this way, the moveable parts like the compressor
and the system in general can be lubricated.
DO NOT loo-
sen any air conditioning system tubes. Contact between the
skin and coolant can cause freezing.
- attEntion
for the maintenance of the air conditioning system,
contact a diEci after-sales centre
.
Compressor belt tension
1. Park the vehicle on a level and compact surface.
2. Switch off the engine and remove the ignition key, hang up
a sign in the cab that reads “maintenance work under way”.
3. Disconnect the battery by acting on the “battery isolator
switch” see page D/14.
4. Wait for the engine to cool.
5. Check compressor belt tension (fig.71 Pos.”1”) every
500 hours.
C
1
(fig.69/D)
(fig.70/D)
C2
1
- attEntion -
Compressor belt tension must be checked in
a diEci after-sales centre .
(fig.71/D)
1
2