Dieci Agri Farmer, Руководство по эксплуатации

Страница: 208 / 272

Maintenance and Registering
D/44
Mod. Agri Farmer
- ATTENTION
:
- Read the SAFETY REGULATIONS (contained in this manual) carefully for the safety of all personnel and your vehicle.
(fig.92/D)
(fig.93/D)
(fig.94/D)
- attEntion -
IT IS MANDATORy TO uSE ThE I.p.D. to carry out the
maintenance/control operations.
Determining wear due to extension
- Verify the type of chain installed, indicated on its external
plate. If it cannot be read, contact a diEci service centre.
- Identify the pitch of the chain on the table (fig.92/D).
(e.g. Fleyer AL8/BL8 Chain Pitch 1”/25.40mm) and mul-
tiply it by 10.
- Measure 10 pitches of the chain to be verified (fig.93/D).
- If the measurement exceeds 2% of the pitch indicated in
the table multiplied by ten, the chain should be conside-
red worn and must be replaced.
2% of the measurement = [Measurement: 100] x 2
- attEntion
Measurements must be taken at several points as wearing
may not be uniform. The chain must also be tight. Measure-
ments can be carried out with a bore or a ruler divided into
millimetres (fig.94/D).
Check, cleaning, lubrication
- Stop the vehicle on a flat, level surface.
- Position the vehicle on outrigger feet (if present).
- Extend the boom completely in a horizontal position.
- Switch off the engine and remove the ignition key, hang up
a sign in the cab that reads “maintenance work under way”.
- Clean the chains to eliminate surface impurities with a
clean cloth that will not leave residue.
- Forcefully brush chains to remove impurities, using a hard
nylon brush and clean fuel. Then blow with compressed air.
- Carefully examine the chains as described in the paragra-
ph “checking for wear”.
- Lightly lubricate the chains with a brush soaked in oil (see
paragraph entitled “lubrication”).
- Remove excess oil from the entire surface of the chains
using a clean cloth.
- Move the boom several times to distribute the oil evenly.
- attEntion
In case of chain replacement, contact a diEci service centre.
- attEntion -
Chains can be made fragile by hydrogen.
- pRohiBition -
OpERATING in acidic environments is
STRICTly pROhIbITED.
Operate for as little time as possible when in oxidative
or corrosive environments.
fleyer chains
fleyer chains
Inch pitch
Mm pitch
Pitch Pitch