Dieci Agri Farmer, Руководство по эксплуатации

Страница: 62 / 272

B/42
Mod. Agri Farmer
Safety Regulations
LOAD TABLES
- ATTENTION -
CHECK THE LOAD TABLES FOR YOUR VEHICLE IN CHAPTER "G”, TECHNICAL SHEETS
The Safe Working Load (SWL) of these vehicles depends on the extension and angle of the boom.
This vehicle is equipped with an anti-tipping device.
For further information on the safe load indicator see the relevant paragraph (in chapter "C" Getting to Know Your Vehicle,
Anti-tipping device").
The load table located inside the cab illustrates the safe working capacities in relation to the various positions of the boom.
The boom extension is marked by letters: "A" "B" "C" "D", etc.
The load table illustrates the maximum height and extension achievable without exceeding the safe load. The telehandler is also
equipped with its own load table. The load table is calculated with standard forks.
When certain attachments are fitted on the vehicle the further Load Tables are supplied.
The load table indicated is for reference purposes only.
Before lifting or positioning modes, consult the relative tables in the book at the side of the steering wheel, or consult chapter "h"
(vehicle technical sheets) in this manual.
- ATTENTION -
The limits given in the load Tables refer to the vehicle at a halt. Do not lift or extend the boom when the vehicle is in motion. Re-
tract the boom completely and lower it as far as possible before moving the vehicle with a load.
Check which boom attachment has been mounted on the vehicle and then consult the relevant load table.
USING THE LOAD TABLES AND BOOM INDICATORS
- ATTENTION -
For your safety and the safety of the vehicle, follow information described below.
- ATTENTION -
The limits indicated in the load tables refer to the stopped vehicle on wheels or outriggers
(if present) on levelled, solid ground.
Do not lift or extend the boom when the vehicle is in motion.
Retract the boom completely and lower it as far as possible before moving the vehicle with a load.
Check which boom attachment has been mounted on the vehicle and then consult the relevant load table.
Before proceeding to lift or put down a load, it is essential that you know how much it weighs.
Make sure the centre of gravity of the load does not exceed 500 mm measured from the heels of the forks.
- ATTENTION -
The centre of gravity of the load may not necessarily be at the centre, you have to therefore work out its position.