Dieci Agri Farmer, Руководство по эксплуатации

Страница: 187 / 272

D/23
- ATTENTION
:
- Read the SAFETY REGULATIONS (contained in this manual) carefully for the safety of all personnel and your vehicle.
(fig.30/D)
(fig.29/D)
2
2 1
3
ChANGING hyDRAulIC OIl AND REplACING
fIlTERS MOD. AGRI fARMER 26.6
The Agri Farmer 26.6 has two tanks; the upper tank is on the
left side between the boom and chassis (fig 30/D Pos. “4”)
and the lower tank is under the base of the raising cylinder
(fig.31/D Pos. “1”).
Inside the upper tank there is a mesh filter (fig.30/D Pos.”3”) are
present inside the tank. These prevent any hazardous particles
from entering the hydraulic system. The replacement of hydrau-
lic oil and internal tank filters must always be carried out in or -
der. It is not possible to service only one of the two components.
To correctly change oil and filters:
- Bring the vehicle to a halt on flat ground.
- Retract the boom completely and lower it to horizontal
position.
- Switch off the engine and remove the ignition key, hang up
a sign in the cab that reads “maintenance work under way”.
- Place a container of appropriate capacity under the dis-
charge cap (fig. 31/D Pos. “1”)
- Remove the drain plugs (fig.31/D Pos.”1”) to drain the
oil. Remove the loading plug (fig.30/D Pos.”2”, fig.31/D
Pos.”2”) to accelerate emptying.
- Once the tank is completely empty, remove the flange
(fig.30/D Pos.”1”), unscrewing its bolts to access the in -
side of the tank.
- Use a fork spanner to remove the filter (fig.30/D Pos.”3”)
inside the tank.
- Insert new filters, tightening them with the fork spanner.
- Reposition the flange (fig.30/D Pos.”1”) in its housing,
and tighten the bolts.
- Reinsert the drain plug (fig.31/D Pos.”1”) and the load
plug (fig.31/D Pos.”2”).
- Fill up the tank to level via its filler cap (fig.30/D Pos.”2”).
- Once the tank has been filled, tighten the top up cap
(fig.30/D Pos.”2”).
- Start up the vehicle and move hydraulic cylinders to dis-
charge any air bubbles.
- Check the hydraulic oil level again and top up if necessary.
waste oil is potentially harmful to the environment and
must always be disposed of appropriately.
- attEntion -
IT IS MANDATORy TO uSE ThE I.p.D. to carry out the
maintenance/control operations.
For the safety specifications, refer to chapter “B”, “Car -
rying out maintenance in safety” paragraph page b/16.
(fig.31/D)
1
4
1
1
2