DGSHAPE DWX-4, Руководство пользователя

Страница: 44 / 53

What to Do If…
44
Chapter 4 Read This Chapter Whenever You Face a Problem. (FAQ)
Is the collet deformed?
The collet may deform if the spindle nose (end of the spindle) strikes against the clamp, etc. or the spindle is locked. If the
collet is deformed, replace it.

P. 31, "Retightening the Collet"
Are the cutting conditions too strict?
Strict cutting conditions may affect cutting results. Review the cutting conditions of CAM.
A Hole Opens in Cutting Result
Is the thickness specified in the cutting data excessively thin?
The finish thickness of workpieces needs to be 0.5 mm or over. Check the thickness specified in the cutting data.
Is the machine out of correction?
The origin point may be out of position due to a long period of use or the relocation of the machine and affect cutting results.
Perform automatic correction. If expected results cannot be obtained even after automatic correction was performed, perform
manual correction. In manual correction, cutting results may be improved by shifting the Z origin point in the + direction.

P. 29, "Correction of Milling Machine"

P. 12, ""Manual correction" Dialog"
Are the cutting conditions too strict?
Strict cutting conditions may affect cutting results. Review the cutting conditions of CAM.
The Dimensions of Cutting Results Do Not Match
Does the diameter of the tool match the settings of CAM? Is the set shrinking percentage proper
for the workpiece?
Check the settings of CAM.
Does the set temperature of the sintering program match the workpiece?
Check the set temperature of the sintering program to see if it matches the workpiece of the manufacturer used.
To Install Driver Separately
The driver, software, and the electronic manual can be installed together on this machine. For the method of
installing them at a time, see "Setup Guide" ( "Installing and Setting Up the Software.” )