DGSHAPE DWX-4, Руководство пользователя

Страница: 30 / 53

Periodic Maintenance
30
Chapter 3 Maintenance

Install the automatic correction jig.
Install the automatic correction jig without making space.
If you align the recess of the tool with the screw hole of the mounting part, you can insert the tool to the end.
Tighten the mounting screw (L) with a hexagonal screwdriver (M).

Close the front cover.
 In the top window of VPanel, select the machine
that you wish to perform automatic correction.
Click [Settings].
The "SETTINGS" window is displayed.

Click [Maintenance] tab.
Click [Automatic correction] tab.
Start the automatic correction by following the displayed instruc-
tions.
 Remove the detection pin and automatic correction jig.
You can remove the automatic correction jig by rotating the mounting screw which secures the automatic correction
jig about 2 turns.
Care and Storage Methods of Detection Pin and Automatic Correction Jig
For correction, you use detection pin and automatic correction jig. The detection pin and automatic correction jig that gather
rust, dust, or scratches will prevent the accurate detection, which may result in the situation where you cannot perform cut-
ting as intended or where the machine should be damaged.
Care and Storage Methods

Before use, wipe clean using the dry clean cloth (included with product), and make sure that any dust,
rust, or scratches are not on the detection pin.

Store in a location with low humidity and little fluctuation in temperature.
OK Not OK
Align the dent with the
position of the screw hole.