DGSHAPE DWX-4, Руководство пользователя

Страница: 52 / 53

Responding to an Error Message
52
Chapter 4 Read This Chapter Whenever You Face a Problem. (FAQ)
The tool is not set, or it is mounted on a wrong stocker number. Set the tool again.
There is a possibility that the ATC magazine may be out of position. Perform automatic correction. If the same message ap-
pears even after automatic correction was performed, the ATC magazine or tool may be contaminated. Clean the machine.
There was something wrong with the cutting data received from the computer. Review the cutting data.
The spindle stopped under a large cutting load. Turn off the power. The cutting conditions may be excessively strict. Review
the settings of CAM and the cutting data.
The spindle motor stopped due to a continued high motor load or instantaneously excessive motor load. Turn off the power.
The cutting conditions may be excessively strict. Review the settings of CAM and the shape specified in the cutting data. In
addition, the motor may be overheated. Keep the spindle motor rested for a while, and restart it.
The dust collector is turned off or powerless. Turn on the dust collector, or check the settings of the dust collector and the filter.
If the tool is too short or if the angle of the A axis is too large, the tool will not reach the cutting position in the Z direction.
Check the tool length and the position of the tool holder.
Check the CAM settings and decrease the angle of the A axis.
1022-**** The % tool is not found. (% may be "1 to 4")
1023-0000 The number of parameters for a RML-1 command received from the computer was incorrect.
1024-0000 The parameter for a RML-1 command received from the computer was out of range.
1025-0000 The RML-1 command from the computer could not be interpreted.
1026-0000 NC code error occurred. Address is not defined.
1027-0000 NC code error occurred. Parameter is not defined.
1028-0000 NC code error occurred. Can not be executed.
1029-0000 The spindle experienced an overload.
102A-0000 The spindle experienced overcurrent.
102D-0000 Spindle rotation is impossible because the spindle shaft is locked or voltage is too low.
102B-0000 The spindle motor temperature is high.
1030-0000 The dust collector is not working.
103D-0000 Milling data error.The tool has not reached the milling position.