DGSHAPE DWX-4, Руководство пользователя

Страница: 29 / 53

Periodic Maintenance
29
Chapter 3 Maintenance
Correction of Milling Machine
The accuracy of the milling machine may vary if it is used for a long period of time or the surrounding environment changes.
With automatic correction, the ATC magazine and the rotary axis will be in the right position.
Cases Where You Need to Perform this Task

When you finish installing the machine

When you finish moving the machine

When the cutting position is misaligned

When there is a level difference or a hole is created in the Z direction, etc. in cutting result
Required Items
·Detection pin · Automatic correction jig ·Hexagonal screwdriver (M) · Cloth for care
Procedure

If a workpiece, clamp, or tool is attached to the machine, remove it.

Remove cutting waste and contamination from the milling machine.
Remove cutting waste according to "Cleaning after Cutting Operation Ends" on page 27.

Clean the detection pin, automatic correction jig and ATC magazine with the supplied cloth
for care.
If any dirt is affixed, correction might not be done properly.

Insert the detection pin to No.1 on ATC magazine.
OK Not OK
Insert the detection
pin firmly.
Clean the tip as well
Clean the dirt on the
back side as well
Part to be wiped
Automatic
correction jig
Detection pin