DGSHAPE DWX-4, Руководство пользователя

Страница: 22 / 53

Starting Cutting
22
Chapter 2 Cutting
STEP2 : Attaching a Tool
Procedure

Place the tool holder on the tool positioner.
Press the tool holder to the end of the hole in the
orientation shown in the figure.

Insert the tool into the tool holder and determine the position.
Insert the tool in the orientation shown in the figure so that the both ends are located within the ranges of the holes
of the tool positioner.
Secure the mounting screw (S) with a hexagonal screwdriver (S).

Set the tool on the ATC magazine.
Insert the tool to the bottom firmly. The ATC magazine can accommodate 2 tools. The tool numbers are printed on
the surface of the magazine.
Tool
Number
Tool
Mounting screw (S)
Tool positioner
Tool holder
Keep the tool holder
with the screw hole up.
Insert the tool to the
bottom firmly.
The state that the each end of the
tool is within the area A and B.