What to Do If…
43
Chapter 4 Read This Chapter Whenever You Face a Problem. (FAQ)
Tool Management Information Was Lost
Did you change any machine name (printer name)?
Tool information is saved by machine name (printer name). Before changing a machine name (printer name), record the
contents of the tool information concerned. The tool information will be recovered by returning the machine name (printer
name) to the original one.
The Cutting Results Are Not Attractive
Is the machine out of correction?
The origin point may be out of position due to a long period of use or the relocation of the machine and affect cutting
results. Perform automatic correction. If expected cutting results cannot be obtained even after automatic correction was
performed, perform manual correction.
P. 29, "Correction of Milling Machine"
P. 12, ""Manual correction" Dialog"
Is the workpiece securely mounted in place?
Check the mounting state of the workpiece. Fasten the workpiece in place securely so that the workpiece will not slip out of
place or come off because of vibration during cutting or tool pressure.
P. 19, "STEP1: Attaching the Workpiece"
Is the tool worn?
If the same tool is used for cutting for a long period of time, it will get worn and affect cutting results. Try to replace the tool
with a new one. The work time of the tool can also be managed by VPanel.
P. 13, ""Tool management" Dialog"
There Is a Line of Level Difference in the Cutting Result
Is the machine out of correction?
The origin point may be out of position due to a long period of use or the relocation of the machine and it causes a line of
level difference in the cutting results. Perform automatic correction. If expected cutting results cannot be obtained even
after automatic correction was performed, perform manual correction. For manual correction, changing the Y value in origin
correction may improve the situation.
P. 29, "Correction of Milling Machine"
P. 12, ""Manual correction" Dialog"
Chipping Occurs (Edges of Cut Workpieces Become Chipped)
Is the tool worn?
If the same tool is used for cutting for a long period of time, it will get worn and affect cutting results. Try to replace the tool
with a new one. The work time of the tool can also be managed by VPanel.
P. 13, ""Tool management" Dialog"
Is the thickness specified in the cutting data excessively thin?
If the specified finish thickness of workpieces is excessively thin, chipping is apt to occur. Review the shape specified in the
cutting data.
Содержание DWX-4
Страница 53: ...R6 171006 FA01214...
