DGSHAPE DWX-4, Руководство пользователя

Страница: 12 / 53

Description of SETTINGS Window
12
Chapter 1 Operation screen
"Manual correction" Dialog
In this dialog, you can make corrections of the milling machine manually. Perform corrections if you want to precisely adjust
the accuracy. When more than one machine is connected, the machine selected in the top window is the target of corrections.
* Perform automatic correction before performing this correction.

P. 29, "Correction of Milling Machine"
Distance
You can correct the moving distance in the X, Y, and Z directions respectively. Set the correction value as considering the
initial moving distance as 100.000%.

Initial setting : 100.000%
A axis back side
You can correct the angle when the A axis is rotated by 180 degrees. Set the correction value as considering the initial
setting as 0.00 degree.

Initial setting : 0.00 degree
Origin point
You can correct the origins of the X, Y, and Z axes, respectively. Set the correction value as considering the initial setting
as 0.00 mm.

Initial setting : 0.00 mm
Clear these values when executing automatic correction
If you check this checkbox, the settings of , , and are reset to the default values when the automatic correction
is performed.

Initial setting : Checked