19
Chapter 2 Cutting
Starting Cutting
STEP1: Attaching the Workpiece
Refer to the appropriate attachment procedure for the workpiece type to be used.
P. 18, "Preparation of Workpieces (Usable Workpieces)"
Block Workpiece
Procedure
Close the front cover, and turn the power switch on.
After the initial operation is completed, open the front cover.
Insert the block workpiece clamp into the mounting part.
Hold the clamp as shown in the figure, and insert it all the way into the mounting part so that there will be no gap
between them.
Tighten the mounting screw (L) with a
hexagonal screwdriver (M).
Loosen the screws of clamp with a hexagonal screwdriver (L) (2 places).
Tighten the screws according to the thickness of the workpiece.
Attach a workpiece from the front side of the clamp.
Screw
Block
work-
piece
Clamp for block workpiece
Mounting part
Insert the clamp so
that there will be no
gap between it and the
mounting part.
Align the dent with the
position of the screw hole.
Mounting screw (L)
Содержание DWX-4
Страница 53: ...R6 171006 FA01214...