DGSHAPE DWX-4, Руководство пользователя

Страница: 18 / 53

18
Chapter 2 Cutting
Getting Ready to Cutting
Preparation of Workpieces (Usable Workpieces)
Type of Workpieces
Zirconia (pre-sintered) , Wax , PMMA, Composite resin
Type and Size of Workpiece
Type
Size (Unit : mm)
Width × Depth Height
Block
76×38 10 to 22
Workpiece with pin
Maximum
85×40
Maximum
22
Preparation for Tool (Size of Tool That Can Be Used)
The tool size that can be used is shown in the figure below.
* The shape of the tool is an example. Select an appropriate tool suitable for usage. To purchase a tool, contact the dealer
where you purchased the milling machine.
Preparation for Supply of Compressed Air (Setting the Regulator)
Recommended Set Pressure
 Zirconia, WAX, Composite resin : 0.1MPa
 PMMA : 0.2MPa
Important Notes on compressed air
Be sure to adjust to an air pressure of not more than 0.2 MPa. Exceeding this may cause malfunction.
When supply of air starts, the air starts to flow and the pressure drops. When the pressure has dropped,
adjust the regulator to have an appropriate value again. (Air is supplied when the spindle rotates or
when the tool is replaced.)
Shank diameter: 4 mm
Length: 40 to 55 mm