What to Do If…
42
Chapter 4 Read This Chapter Whenever You Face a Problem. (FAQ)
Is the area around the ionizer covered with cutting waste?
If cutting waste adhere to this area, remove them with a dust collector. The ionizer may become less effective if cutting waste
adhere to this area. Do not touch the inside of the ionizer.
P. 29, "Correction of Milling Machine"
Is the machine grounded?
If the machine is not grounded, the effect of the ionizer can not be obtained.
Compressed Air Does Not Come Out
Is any of the operations which need compressed air being performed?
Compressed air is only supplied during some operations, such as the rotation of the spindle or the replacement of the tool.
Is the connection or pressure of the regulator set correctly?
Check the regulator for connection. Check if the memory of the regulator is 0. If the set pressure of the regulator is 0, com-
pressed air will not be supplied.
"Setup Guide" ("Preparing the Regulator")
P. 18, "Preparation for Supply of Compressed Air (Setting the Regulator)"
Is the knob at the bottom of the regulator open?
If the knob at the bottom of the regulator is open, compressed air flows out.
P. 33, "Care and Maintenance of the Regulator"
Abnormal Noise Occurs
Are the shaft and the drive screws contaminated? Has the grease run out?
Clean the guide shaft and the drive screws, and apply the attached grease to them. The machine is likely to generate noise
at the initial stage after introduction. If abnormal noise occurs, apply the grease to the drive screws.
P. 35, "Cleaning the Inside and Applying Grease"
Automatic Correction Fails
Is the automatic correction jig, detection pin, or ATC magazine contaminated?
Remove contamination on the automatic correction jig, detection pin, or ATC magazine if they are contaminated. If they
are contaminated due to buildup of cutting waste or the like, the sensor cannot operate correctly, making correct detection
impossible.
P. 29, "Correction of Milling Machine"
Is the automatic correction jig properly attached?
Check the automatic correction jig to see if it is properly attached.
Is the detection pin properly attached?
Check the detection pin to see if it is properly attached. Check the position of the tool holder attached to the detection pin.
P. 29, "Correction of Milling Machine"
"Setup Guide" ("Specifications" "Detection Pin Dimension").
Содержание DWX-4
Страница 53: ...R6 171006 FA01214...
