Delta OHM DO 9709, Инструкция по эксплуатации

Страница: 19 / 82

97
KEY SIMBOLS LIT BESIDES
THE NUMBERS
FUNCTION
DESCRIPTION
SERIAL OUTPUT
P12+ =
calibrate
pressure sensor
- P12 -
Pressing the PROG key moves
on to step P0.
When ENTER is pressed with
P12 on the display, the instrument
enters the program for calibrating
the pressure sensor.
The display shows the message
PrS at the top of the display and,
at the bottom, the pressure value
measured in mbar.
Both the °C and °F indications are
active.
At this point, by pressing the
ENTER key it is possible to return
to normal operating mode, obtai-
ning only the display of the mea-
sured pressure.
Pressing the PROG key begins
the procedure for calibrating the
pressure sensor.
For greater details, see the instru-
ment pressure calibrating instruc-
tions.
Serial Output key. The Serial
Output key sends the data being
acquired onto the serial line
immediately, according to the set
programming parameters.
Note:
The choice of the baud rate
influences the speed at which the
data are sent onto the serial line.
ENGLISH
°
F
°
C
mg/l
Serial
Out
Memory
°
C