Dell PowerEdge T410, Руководство владельца оборудования

Страница: 140 / 204

140
Installing System Components
4
Locate the battery socket. See "System Board Connectors" on page 178.
CAUTION:
To avoid damage to the battery connector, you must firmly support the
connector while installing or removing a battery.
5
Remove the system battery.
a
Support the battery connector by pressing down firmly on the positive
side of the connector.
b
Press the battery towards the positive side of the connector and lift it
up out of the securing tabs at the negative side of the connector.
6
Install the new system battery.
a
Support the battery connector by pressing down firmly on the positive
side of the connector.
b
Hold the battery with the "+" facing up, and slide it under the
securing tabs at the positive side of the connector.
c
Press the battery straight down into the connector until it snaps
into place.
7
Close the system. See "Closing the System" on page 91.
8
Place the system upright and on its feet on a flat, stable surface.
9
Rotate the system feet outward.
10
Reattach any peripherals and connect the system to an electrical outlet.
11
Turn on the system and attached peripherals.
12
Enter the System Setup program to confirm that the battery is operating
properly. See "Using the System Setup Program and UEFI Boot Manager"
on page 61.
13
Enter the correct time and date in the System Setup program's Time and
Date fields.
14
Exit the System Setup program.
book.book Page 140 Tuesday, June 9, 2009 4:09 PM