Installing Hard-Disk Drives
10-3
Set the SCSI ID on all drives to 0. All SCSI ID numbers for the drives are set by
the SCSI backplane board, as shown in Figure 10-2.
Configure the drive so that the drive motor waits for a Start Unit command from
the SCSI host adapter before spinning.
)LJXUH6&6,%DFNSODQH%RDUGV
1 x 6 hot-pluggable SCSI backplane board
2 x 3 non-hot-pluggable SCSI backplane board
2 x 2 non-hot-pluggable SCSI backplane board
SCSI ID 0
SCSI ID 5
SCSI ID 0
SCSI ID 5
SCSI ID 0
SCSI ID 3
32268BK0.BK : 32268100.FM Page 3 Monday, March 16, 1998 8:56 AM