3-4
Dell PowerEdge 2300 Systems Installation and Troubleshooting Guide
Hard disk
controller
failure
Hard disk
drive read
failure
Hard disk
failure
Incorrect configuration
settings in System Setup
program, improperly
connected hard-disk
drive, faulty hard-disk
drive controller
subsystem (defective
system board), or loose
power cable
Check the hard-disk drive
configuration settings in the
System Setup program. See
Chapter 4, “Using the System
Setup Program,” in the
Dell
PowerEdge 2300 Systems
User’s Guide for instructions.
Reinstall the hard-disk drive.
Check the interface cable and
power cable connections to
the backplane board. See
Chapter 10, “Installing Hard-
Disk Drives.”
Invalid
configuration
information -
please run
SETUP program
Incorrect ISA_CLR
jumper configuration,
incorrect configuration
settings in System Setup
program, or faulty bat-
tery
Remove the plug from the
ISA_CLR jumper. See Appen-
dix B, “Jumpers and
Switches,” for instructions.
Check the System Setup con-
figuration settings. See Chap-
ter 4, “Using the System Setup
Program,” in the
Dell Power-
Edge 2300 Systems User’s
Guide for instructions. Replace
the battery. See Chapter 8,
“Installing System Board
Options.”
Invalid CPU
speed detected
- check jumpers
Incorrect microproces-
sor jumper configuration
Check the microprocessor
speed jumper. See Appendix B,
“Jumpers and Switches.”
Invalid NVRAM
configuration,
resource
reallocated
System detected and
corrected a resource
conflict when system
resources were allo-
cated using the
Resource Configuration
Utility
No action is required.
I/O parity
interrupt at
address
Expansion card improp-
erly installed or faulty
Reinstall the expansion cards
(see Chapter 8, “Installing Sys-
tem Board Options”). If the
problem persists, replace the
expansion card.
7DEOH6\VWHP0HVVDJHV
FRQWLQXHG
0HVVDJH
&DXVH
&RUUHFWLYH$FWLRQ
NOTE: For the full name of an abbreviation or acronym used in this table, see the abbreviation and
acronym list that precedes the Index.
32268BK0.BK : 32268C30.FM Page 4 Monday, March 16, 1998 8:56 AM