Dell Latitude XT PP12S, Руководство пользователя

Страница: 160 / 230

160
NOTE:
Lift the keyboard carefully in step 4 to ensure that you do not pull on the
keyboard cable.
4
Rotate the keyboard up 45-degrees to gain access to the keyboard
connector.
5
Pull up on the pull-tab to disconnect the keyboard cable from the keyboard
connector on the system board.
6
Pull the track stick cable from the track stick connector on the system
board.
7
Lift the keyboard from the system and place to one side.
Installing the Keyboard
NOTE:
When you replace the keyboard, ensure that the keyboard tabs are
completely in place to avoid scratching the palm rest.
1
Slip the track stick cable into the track stick cable connector on the system
board and press the connector clip down to hold the cable in place.
2
Insert the keyboard cable into the keyboard cable connector on the system
board and press the connector clip down to hold the cable in place.
3
Holding the keyboard at a slight angle, insert the four metal tabs of the
keyboard into the four metal slots of the palm rest.
4
Tighten the two M2 x 3-mm screws at the top of the keyboard.
5
Install the hinge cover (see "Installing the Hinge Cover" on page 158).
Coin-Cell Battery
CAUTION:
Before performing the following procedures, follow the safety
instructions in your Product Information Guide .
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist
grounding strap or by periodically touching a connector on the back panel of the
Tablet-PC.
NOTICE:
To avoid damaging the system board, you must remove the main battery
before you begin working inside the Tablet-PC.
Removing the Coin-cell Battery
1
Follow the procedures in "Before You Begin" on page 139.