Dell EMC PowerEdge R940xa, Инструкция по установке и обслуживанию, Страница: 42 / 177

Option Description
available only for UEFI boot mode. You cannot set the option to Enabled if UEFI Secure Boot mode is enabled.
This option is set to Disabled by default.
Dell Wyse
P25/P45 BIOS
Access Enables or disables the Dell Wyse P25/P45 BIOS Access. This option is set to Enabled by default.
Power Cycle
Request Enables or disables the Power Cycle Request. This option is set to None by default.
iDRAC Settings utility
The iDRAC settings utility is an interface to set up and configure the iDRAC parameters by using UEFI. You can enable or disable various
iDRAC parameters by using the iDRAC settings utility.
NOTE: Accessing some of the features on the iDRAC settings utility needs the iDRAC Enterprise License upgrade.
For more information about using iDRAC, see Dell Integrated Dell Remote Access Controller User's Guide at www.dell.com/idracmanuals .
Device Settings
Device Settings enables you to configure the device parameters.
Dell Lifecycle Controller
The Dell Lifecycle Controller (LC) provides advanced embedded systems management capabilities, including system deployment,
configuration, update, maintenance, and diagnosis. LC is delivered as part of the iDRAC out-of-band solution and Dell system embedded
Unified Extensible Firmware Interface (UEFI) applications.
Embedded System Management
The Dell Lifecycle Controller provides advanced embedded system management throughout the system’s lifecycle. The Dell Lifecycle
Controller can be started during the boot sequence and can function independently of the operating system.
NOTE: Certain platform configurations may not support the full set of features provided by the Dell Lifecycle Controller.
For more information about setting up the Dell Lifecycle Controller, configuring hardware and firmware, and deploying the operating
system, see the Dell Lifecycle Controller documentation at
www.dell.com/idracmanuals .
Boot Manager
The Boot Manager screen enables you to select boot options and diagnostic utilities.
View the boot manager
Perform the following steps to enter the boot manager.
Steps
1. Turn on, or restart your system.
Enter the result of your step here (optional).
2. Press F11 when you see the following message:
F11 = Boot Manager
If your operating system begins to load before you press F11, allow the system to complete the booting, and then restart your system
and try again.
42 Pre-operating system management applications