Dell EMC PowerEdge R940xa, Инструкция по установке и обслуживанию, Страница: 133 / 177

Figure 100. Removing the MicroSD card
Next steps
1. Replace the MicroSD card .
Installing the MicroSD card
Prerequisites
1. Follow the safety guidelines listed in Safety instructions .
2. Follow the procedure listed in Before working inside your system .
3. Remove the support bar .
4. Remove the air shrouds .
5. Remove the expansion card riser .
6. Remove the IDSDM or vFlash module .
NOTE: To use an MicroSD card with your system, ensure that the Internal SD Card Port is enabled in System Setup.
Steps
1. Locate the MicroSD card connector on the IDSDM or vFlash module. Orient the MicroSD card appropriately and insert the contact-pin
end of the card into the slot.
NOTE: Ensure that you install the MicroSD cards into the same slots based on the labels you had marked on the
cards during removal.
2. Press the card into the card slot to lock it into place.
Next steps
1. Replace the expansion card riser .
2. Replace the air shrouds .
3. Replace the support bar .
4. Follow the procedure listed in After working inside your system .
Installing and removing system components 133